| Notes |
The Lathe. Mounting work in the lathe, finding centre of end of shaft, centre-punching end of shaft, bell-centreing punch, driving work between centres, combined counter-sinking & drilling, correct fit of work on lathe centre, use of square centre for truing recess in shaft, mounting work in chucks, ordinary driver-plate & carrier, double equalizing driver-plate, bell chuck, mounting work on the faceplate, difference in top angles of turning tools for iron & brass, facing large daimeters, parallel and taper turning, parallel & taper boring, methods of boring, facing with cranked & knife tools, forming tool finishing complete profile, facing or surfacing, cutting external & internal threads, chasers, forming, undercutting & recessing, parting or cutting off, knurling, cutting screw-threads, typical tool-holders for square & rectangular vee-shaped steel, characteristic shape of turning tools, showing combined top & side rake, special settings of tool's noses for roughing traverses, parallel turning, taper-turning with top-slide swivelled, taper with poppet, comparison of roughing tools |